Dongguan Jitian Machinery Co., Ltd.
Q Q： 281732381
Address：No. 65 Of Chiling Section,GuanTai Road,HouJie Town,DongGuan City
Introduction and maintenance of plastic sheet trimming shredder
The use of the first no-load test for 1-2 minutes, to be observed without abnormal phenomena before feeding, feeding should gradually increase the flow, and at any time to observe the power consumption and operation of the motor to be feeding and power balance after the normal operation, Decided to die under the brake, to work. If the material is too wet, too much sticky material, affecting the powder, the material should be dried or replace the thicker sieve. Replace the sieve plate only to open the front cover can be carried out, the installation of the front cover should pay attention to both sides of the hand wheel tight match to ensure that the front cover and chassis seal. Stop the feeding before stopping, let the machine run for 5-20 minutes before stopping. In order to reduce the residual material.
Regularly check the bearings, replace the high-speed butter, to ensure the normal operation of the machine, to always check the wearing parts, if serious wear and tear to be replaced.
Plastic machinery, such as the spindle speed is gradually reduced, you must adjust the motor down, so that the machine can achieve the required speed, found abnormal should stop check